Over time and due to use, the toilet bowl starts to leak. This constitutes a plumbing failure for the entire toilet. It is then necessary to take this failure into account and solve it as soon as you notice. check this article for what to do when the toilet bowl leaks?
Toilet bowl leaks, possible causes, and how to solve the flushing problem?
Toilet leakage is a problem that must be solved quickly, otherwise, your water bill will increase. For this, read review of this failure. Also, over time, even a small leak can cause significant damage to you or your neighbors. Leaks can occur in several places: between the toilet seat and the floor, the water inlet, or the toilet itself. On the floor, either the water tank is leaking or the drain seal is damaged. At the water supply level, limescale or the age of the faucet can be the cause. Finally, in the toilet itself, the problem is the flush. Fixing this can be very simple. When the flush water leaks, two manifestations can be identified: the water tank continues to add water, the water tank fills up from time to time. In this case, the reason is the same as when the water does not stop.
The intervention float
The most common cause of toilet leaks is when the floats fail. Even if the fuel tank is full, it no longer rises sufficiently. Water then continuously flows into the bowl through the overflow system. If the float does not rise, it may be punctured. it can no longer perform its function, so it must be replaced. But limescale can also build upon its rising stems. Then, what you need to do is: turn off the tap, flush the toilet to empty the water tank, unscrew the flushing action system and open the water tank, clean the stick to remove the limescale by rubbing it with the abrasive surface of a dish sponge, or using white vinegar or lemon.
Finally, change the flushing mechanism. If the leakage persists, the cause is the bell or the valve. Their movements will become blocked, either because of limescale or because of aging mechanisms. You unscrew the screw under the saddle to remove the water tank. Empty the water that may remain at the bottom. You can place the water tank on a flat surface so that it can easily reach the bottom. Remove the seal and remove the remaining parts. Before installing the new mechanism, take the opportunity to replace the outer gasket, that is, the gasket between the valve seat and the fuel tank (the inner gasket is included in the new mechanism you are installing).
Similar articles
